View single post by Marcello_GT
 Posted: Sat May 31st, 2008 06:32 am
PM Quote Reply Full Topic
Marcello_GT

 

Joined: Sat Feb 2nd, 2008
Location:  
Posts: 31
Status: 
Offline
 Skipdawg wrote: <snip>
Not quite sure how it was done but due to the precision I would assume no less than a utility or craftsman's scalpel. Would need to be very careful with a steady hand.
Thanks for the input, sir! Some folks have mentioned a Dremel attack, so the methods do seem to vary with the occasion. I guess I'll look into it a bit further before doing mine.

Thanks again!