View single post by hucky
 Posted: Wed Jul 2nd, 2008 04:25 pm
PM Quote Reply Full Topic
hucky



Joined: Mon Sep 3rd, 2007
Location:  
Posts: 2242
Status: 
Offline
 You have to take off the end pieces, use the Arrow directions that are on the bracelet, It shows you the direction, Push them out, you need a tool for this.

 

Once you have the end pieces off you need to file each end equally to get you to your desired fit. Use a Fine file small or a fine grinder. Push the pins back in, watch your direction and your done. 

check the spring bar holes you may or may not be able to use Fat Spring Bars, the new ends you can, some of the older ones you cannot.

Piece of cake

cheers