View single post by spaceghost33
 Posted: Tue Sep 23rd, 2008 10:57 am
PM Quote Reply Full Topic
spaceghost33

 

Joined: Sat Jul 5th, 2008
Location:  
Posts: 4
Status: 
Offline
 I received my Eco-Zilla adapters today (from Walter). I carefully went about removing the screws from the back retaining ring on my Ti Eco-Zilla. Turns out, the first few threads of two (of the 4) screw holes are stripped. The screw goes in fine without the retaining ring on the watch caseback, but with the ring, the screw doesn't reach down into the hole far enough to grab the remaining good threads. Any advice on fixing this problem? Does anyone know of slightly longer screws of the same style that would work with this watch. The current screws are tapered and 8.13mm long. Any help would be greatly appreciated.

Thanks,

~Chris