 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Thu Sep 29th, 2005 |
| Location: | Clinton Twp, Michigan USA |
| Posts: | 12862 |
| Status: |
Offline
|
I received my Eco-Zilla adapters today (from Walter). I carefully went about removing the screws from the back retaining ring on my Ti Eco-Zilla. Turns out, the first few threads of two (of the 4) screw holes are stripped. The screw goes in fine without the retaining ring on the watch caseback, but with the ring, the screw doesn't reach down into the hole far enough to grab the remaining good threads. Any advice on fixing this problem? Does anyone know of slightly longer screws of the same style that would work with this watch. The current screws are tapered and 8.13mm long. Any help would be greatly appreciated.
Thanks,
~Chris
I'm not very mechanically inclined, but if the screw is long enough and only the first 2 threads of " the hole" are stripped why would you not be able to screw the screw in after that point??
Maybe someone can interject. I dont think Citizen would manufacture anything like that.