 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Sun Sep 4th, 2005 |
| Location: | Akron, USA |
| Posts: | 28901 |
| Status: |
Offline
|
Ty Eric...I am going to try this ...How Bad could it Turn Out...Right :P:P
On the bezel, I went in one direction...then switched and went the other way. I went from 12 o'clock to 6 o'clock. As opposed to up and down in the scallops. I rolled the paper up the width of 2 toothpicks...and just skated the half pipe. You will develop a technique that works best and you will notice. I prefer the 12 to 6 o'clock as it is easier to cover more area smoother. The beauty of it is it is all reversible or easily corrected should you spot a section that is a bit off...you simply pass the paper over it again til it looks good.
It's really just trial and error til you get a system that works well on a particular section of the watch.