View single post by IW
 Posted: Mon Nov 27th, 2006 10:06 pm
PM Quote Reply Full Topic
IW



Joined: Mon Apr 3rd, 2006
Location: Huntington, New York USA
Posts: 1400
Status: 
Offline
Eric can help with the proper terminology here, but. . .

I'm fairly sure its the cannon pinion. It slides over the main shaft. If its too tight, the rotor will spin when you wind the watch. Too loose, the watch won't wind properly.

I think.

Marc

mcwright wrote:
One of my favorite Trias watches (Swiss Made 17 jewel ETA 2824) has a problem. The rotor spins (quite a bit) with each turn on the crown to hand wind it. I'm not sure when this started, but it is really noticeable now. The rotor spins like a top when I hand wind the watch.

Is this a keyworks problem? Or, is it something else? Thanks!